Silk head scarf measuring 10" (25 cm) wide by 15.5" (39 cm) long with covered elastic measuring 1" (25 mm) wide by 6" (15 cm) long.
- Woven fabric, like lightweight cotton, linen, silk chiffon, or silk charmeuse
- 1" (25 mm) wide elastic--you'll need a length of about 6" (15 cm), but you can wait to cut it until the fitting stage
- Safety pin or loop turner
Measuring and Cutting
- Main Piece: Cut 1 rectangle from your fabric as shown in Diagram 1. You can vary the width quite a bit depending on how much of your head you want covered; I'd say 6" (15 cm) to 13" (33 cm) is the general range for this style.
- Connector Piece: Cut 1 rectangle from your fabric as shown in Diagram 1. The 2.75" (70 mm) dimension is sized for 1" (25 mm) wide elastic. If you choose a different width for your elastic, update this dimension by multiplying the width of your elastic by 2 and adding 0.75" (19 mm).
Note: Any grainline orientation should be fine, but laying the long sides of the rectangles crosswise (i.e., perpendicular to the selvage) will use the least fabric yardage.
- Hem the long raw edges of the main piece by folding each raw edge 0.25" (6 mm) to the wrong side twice, as shown in Diagram 2. Sew along the upper edge of the hem. If you are using a very lightweight material like chiffon and/or using a rolled hem presser foot, you can sew a narrower 0.125" (3 mm) hem.
- Pleat or gather the short, raw edges of the main piece so that they are the same width as the elastic, 1" (25 mm) in this case. See Diagram 3. To gather, sew a gathering stitch (i.e., a long, straight stitch with the tension loosened) within the 0.5" (13 mm) seam allowance, leaving long thread ends; pull the thread ends to gather the edge to the width of the elastic and then tie the threads. To pleat, try using overlapping knife pleats and sew a basting stitch within the 0.5" (13 mm) seam allowance to hold down the pleats.
- Fold the short sides of the connector piece in half with right sides together and, using a 0.25" (6 mm) seam allowance, sew the long raw edges together to create a tube as shown in Diagram 4.
- Turn the connector piece right side out with a safety pin or loop turner and press so that the seam is positioned at center back (CB).
- Fold and press the raw edges of the connector piece 0.25" (6 mm) to the inside of the tube.
- Insert the elastic inside the connector piece tube and pin the connector piece onto the elastic so that the elastic sticks out on both ends.
- Overlap one end of the elastic 0.5" (13 mm) onto one of the raw ends of the main piece and sew them together as shown in Diagram 5. Test the fit by trying on the headband while stretching the elastic to the unattached end of the main piece. Cut elastic to desired length. Overlap and sew the unattached ends of the elastic and main piece like you did on the other side.
- Slide the ends of the connector piece just past the elastic ends, keeping the raw edges of the connector piece folded inside the tube. Topstitch next to the folded edge of one of the connector pieces. Topstitch again about 0.25" (6 mm) further down the connector piece. See Diagram 6. Repeat the topstitching on the other side.